56
12.
After checking that all fittings are tight, return the water distiller head to the
upright position and reinstall on the charcoal filter canister and storage
tank. Reconnect the control cable plug on the storage tank to the control
cable receptacle on the bottom of the water distiller head by turning the
plug until the splines lock and then turn the locking ring until finger tight.
13.
Attach the drain hose to the barbed coupler secure with a gear clamp
using a slotted screwdriver. Connect the wall stabilizer clamp. Run the
drain hose to a suitable floor drain. The drain hose must have an air gap
between the end of the hose and the floor drain. The air gap is necessary
so that water cannot be siphoned up the drain hose into the boiling
chamber and also so that sewage gases do not rise up the drain hose and
contaminate the water distiller.
14.
Connect the feed water line and turn the feed water line saddle valve on.
15.
Connect the two-pin plug from the motorized drain valve into the
receptacle labelled ‘Accessory Drain
’
on the bottom of the water distiller
head. If the PWS APK-1 Pump Kit is installed on the water distiller
connect the two-pin plug from the pump into the receptacle labelled
‘Accessory Pump’.
17.
Plug the electrical cord into the wall outlet. Leave the ball valve in the
open position during normal operation. The distiller is now ready to
operate and drain the boiling tank automatically.
NOTE:
With the automatic drain kit installed the ball valve is always left
open while the water distiller is operating. When the water distiller is
shut down for cleaning, the ball valve needs to be closed so the
cleaning solution in the boiler tank will not drain out. This procedure is
described in more detail in the maintenance section of the guide.
NOTE:
PWS APK-1 Pump and PWS AED-1 cord lengths are designed
so they cannot be plugged into the incorrect receptacle.
