13
Place the footrest assembly onto the two socket
head screws on the chassis. Use the keyhole pattern
that offsets the footrest assembly toward the top
end of the chassis.
Connect the wire harnesses between the chassis and
footrest assembly.
Level the footrest and tighten the (4) socket head
screws (2 in front and 2 on back).
Note that the ETL
listing is valid only when the track installed at maxi-
mum angle of 45°.
The swivel stop is factory set for a left
-
hand unit. If the
lift is installed on the right
-
hand side of the staircase,
move the seat swivel stop screw to the opposite hole on
top of the footrest assembly.
Place the plastic thrust washer onto the swivel pin.
Place the seat assembly onto the swivel pin. It
may be necessary to lubricate the swivel pin.
Verify the seat swivels the proper direction.
Route the wire harness from the seat control
through the hole in the back of the footrest verti-
cal plate and connect to the mating connector.
Replace the front cover.
Turn on the red RESET/OFF switch to power up
the chassis located on the top of chassis.
The lift can now be operated by the unit control
and the wireless key fobs.
Seat Swivel Stop Screw
(Shown in LH position)
RH
position
Thrust Washer
Swivel Pin
Wire
Harness
Footrest
Assembly
Route Seat
Harness thru hole
Footrest
Vertical Plate
