1. Installing the luminaire
WARNING
switch off power to mains
before installation.
Install Basis Track components as per
Basis Track instructions supplied.
Remove the Magnetic Front Plate from
the luminaire using a flat screw driver as
a pivot. Loosen the Locking Screws with
a 2.5mm allen key. Pull the two luminaire
segments apart.
Place the Upper Luminaire Segment
over the Basis Track.
Push the Lower Luminaire Segment
Alignment Pins into the corresponding
holes in the Upper Luminaire Segment.
Tighten the Locking Screws to securely
attach the luminaire to the track.
WARNING
Locking Screws must be
tightened securely to ensure good electrical
connection and secure mounting to track.
Alignment Pins alone are not sufficient.
Replace Magnetic Front Plate.
Model shown is the Basis Track Domino 2.
The same procedures apply for Basis Track
Domino 4 and 1 variations.
