Helios Large Display Temperature Meter Instruction Manual
PD2-7000
20
Setup and Programming
The meter is factory calibrated prior to shipment to read
temperature in degrees Fahrenheit. The calibration equipment
is certified to NIST standards.
Overview
There are two switches, located to the right of the signal input connector, used to set the input selection
for thermocouple or RTD and for 100-ohm platinum or 10-ohm copper. The 1000-ohm RTD input uses the
same setting as the 100-ohm.
Setup and programming is done through the programming buttons located under the front door panel.
After power and input signal connections have been completed and verified, apply power to the meter.
www.
.com
1.800.561.8187
