PDW30 & PDW90 Repeater Field Unit
Instruction Manual
5
Safety Information
•
Read complete instructions prior to installation
and operation of the device.
•
Read all product labels completely and follow all
instructions and requirements listed on the labels
for installation or service.
•
Installation and service should be performed only
by trained service personnel. Service requiring
replacement of internal components must be
performed at the factory.
Installation
All pushbuttons and wiring connectors are accessed
by opening the enclosure. To access electrical con-
nectors, remove the 2 captive screws and remove the
display assembly. Pushbuttons may also be accessed
using the magnet assembly if reed switches are in-
stalled.
Unpacking
Remove both units from box. Inspect the packaging
and contents for damage. Report damages, if any, to
the carrier. If any part is missing or the units malfunc-
tion, please contact your supplier or the factory for as-
sistance.
Pre-Installed Conduit Plug
The PDW30-RNA is supplied with one pre-installed
optional conduit plug for installations that do not re-
quire the use of both conduit entries. The conduit plug
includes an internal hexagonal socket recess for re-
moval.
Mounting Instructions
The PDW30-RNA has two mounting holes that may
be used for a 1.5" pipe mounting or wall mounting.
Alternatively, the unit may be supported by the con-
duit using the conduit holes provided. The antenna is
threaded into one of the three conduit holes and may
be moved as appropriate for the installation.
It can also be mounted by using the PDA6963 mount-
ing bracket in order to orient the device antenna away
from the pipe. Refer to
for details on wall or panel space requirements.
Cover Jam Screw
The cover jam screw should be properly installed
once the wireless units have been wired and tested in
a safe environment. The cover jam screw is intended
to prevent the removal of the units’ cover while in op-
eration without the use of tools. Using a M2 hex
wrench, turn the screw clockwise until the screw con-
tacts the unit. Turn the screw an additional 1/4 to 1/2
turn to secure the cover.
•
Excess torque may damage the threads and/or
wrench.
FCC Notice
Contains FCC ID: MCQ-XB900HP
The enclosed device complies with Part 15 of the
FCC Rules. Operation is subject to the following two
conditions: (i.) this device may not cause harmful in-
terference and (ii.) this device must accept any inter-
ference received, including interference that may
cause undesired operation.
