Precision Digital Corporation PD8-6262, Instruction Manual

Page: 20 / 70

PD8-6262 Explosion-Proof Dual Analog Input Flow Rate/Totalizer
Instruction Manual
20
Mounting
The ProtEX-MAX has four slotted mounting flanges
that may be used for pipe mounting or wall mounting.
Refer to
Figure 1 and Figure 2 below.
•
Do not attempt to loosen or remove flange bolts
while the totalizer is in service.
Mounting Dimensions
All units: inches (mm)
Figure 1. Enclosure Dimensions
– Front View
Figure 2. Enclosure Dimensions
–
Side Cross Section View
Wall Mounting Instructions
The totalizer can be mounted to any wall or flat
surface using the four provided mounting holes
located in the cast-in flanges. In addition, the internal
electronic assembly can be rotated to allow the
enclosure to be mounted in any position. To mount
the totalizer to a wall, follow these instructions:
•
Prepare a section of wall approximately
7" x 8.5" (178 mm x 216 mm) for totalizer
mounting by marking with a pencil the
mounting holes (shown in
Figure 1 ) on the
wall.
• Select the appropriate mounting screws for the
mounting surface to be used. The mounting
holes diameter is shown on
Figure 1 .
Note: Mounting screws are not included.
•
Using a drill bit slightly smaller than the girth
of the mounting screws, pre-drill holes at the
mounting locations previously marked.
•
Insert mounting screws into the four mounting
holes and screw them into the pre-drilled
holes.