Prebena 3X-CNW50, Operator'S Manual

Page: 66 / 315

Preparation of the fastener driving tool
16
Checking the condition
WARNING
Danger of injury when operating a damaged
fastener driving tool or if an accessory is not
fastened correctly.

Check the condition of the fastener driving tool every time before
using it.

Make certain the fastener driving tool is in flawless condition.

Check the following points in particular:
-
The hose line must be undamaged.
-
All the parts of the fastener driving tool and all accessory parts
must be securely fastened.
-
The safety devices must not be blocked or otherwise adversely
affected in terms of their function.
-
The spring of the triggering safety device must not be damaged.
-
There must be no external damage such as scratches or dents
visible on any parts of the fastener driving tool or the accessory.
 Scratches in the paint on the housing or magazine are not
considered damage.

If a fastener driving tool is damaged, do not connect it
to a compressed air supply.

If a fastener driving tool is damaged, have it repaired
by a qualified specialist before you place it in operation.
Connecting the fastener driving tool to the compressed air
supply
You can connect the fastener driving tool to a compressor
or to a compressed air system.
Operation with a compressor or compressed air system is only possible
if the following preconditions are met:

The operating pressure of the compressor or compressed air system
must be no more than 10 % above the maximum operating pressure
of the fastener driving tool. Information about the operating pressure
of the fastener driving tool can be found in this section on page 29.

For compressed air systems with a higher pressure, a pressure
control valve (pressure reducer) with a downstream pressure limiting
valve must be installed in the compressed air line.