TX=
X
Enable/Disable output command. TX=1 turns
the output on for the current channel. TX=0
turns the output off for the current channel.
If current CH is scanning transmitter will report:
DISABLE CHANNEL BEFORE MAKING CHANGE
If current CH is armed for scanning but not
scanning, transmitter will report:
OK. SCAN DISARMED
ST=
X.yyyy
Sets the channel spacing (in MHz).
Example: ST=0.0125 (12.5 kHz Channel
Spacing)
SCANSU_X_YYYY_ZZ.z
Scan Setup, where X is 1 or 2 (the physical
channel being set up for scanning. YYYY is
either AB, ABC, or ABCD (the setups being
armed for schanning). ZZ.z is a number
between 0.2 and 99.9 seconds (The desired
dwell time).
The addressed channel cannot be currently
active.
Example: SCANSU 2 ABC 12.2
Sample alerts:
-
DWELL TIME MUST BE 0.2 TO 99.9 SECS
- DISABLE SCAN BEFORE CHANGING SCAN
PARAMETERS
- SCAN ORDER NOT VALID FOR THIS CHANNEL