Default: Push-button
This procedure lets you choose the type of wired devices to command load 1 (connected on terminal 3, input P1). The devices can
be set as push-buttons or switches.
PROCEDURE
1- Position DIPs 1, 2, 3 and 4 to OFF-OFF-ON-ON.
2-
Press the button on the receiver for a short time. The LED comes on and stays on
3- Press the button on the receiver for a short time, count the number of flashes emitted by the LED:
3 flashes = control with push-buttons
6 flashes = control with switches
WARNING: to change the setting, repeat the procedure from point 1; the control unit will alternate between 3 and 6 flashes.
WARNING: after programming, reposition the dip switches to the desired operation of the contacts
(see paragraph 4.1)
4.3
SETTING TYPE OF INPUTS VIA WIRE "P1"
ON
1 2 3 4
ON
1 2 3 4
5.1
RADIO PROGRAMMING MULTIFUNCTIONAL TRANSMITTERS
5 - RADIO PROGRAMMING
This procedure can be used only to programme compatible multifunctional transmitters; see table 5.1. The transmitter's
command modes depend on the model used and the setting of the outputs (see paragraph 4.1). Refer to the transmitter
manual, to the paragraph entitled "commands sent by the transmitter", bearing in mind that:
Output set as monostable = monostable device.
Output set as bistable = on/off device.
Output set as timer = timer device.
PROCEDURE:
1- Position DIPs 1, 2, 3 and 4 to ON-ON-ON-ON.
2- Press the button on the receiver for a short time. The LED comes on and stays on.
3- Make a transmission with the remote control to be saved (see transmitter manual,
the paragraph entitled "transmitter programming"). The LED on the receiver flashes 3
times to signal that it has been received.
4- The control unit listens for 30 seconds (to immediately exit the procedure press
the button on the receiver).
WARNING: after programming, reposition the dip switches to the desired operation of the contact
(see paragraph 4.1)
Tab. 5.1
COMPATIBLE
TRANSMITTER
DOM-TX15
