Practical Automation ITK1 G Series Quick Setup Manual Download Page 1

Page: 1 / 4

Rev C (8-18-2020)

ITK1xG

PRINTER QUICK SET-UP GUIDE

When you first set up your printer, follow these simple steps to properly configure your printer to

your specific tickets and/or application



Measure target Ticket Length (C), and distance from cut line to Top of Mark (D) in millimeters (mm)



Find the ITK12 or ITK123 driver icon (different paths depend-
ing on version of Windows), and open the “PA ITK12xG
Properties” driver utility



Select “General” tab



Select “Preferences”



Select preferred orientation, then select “Advanced” button



Under “Paper Size”, select correct ticket size, press “OK”



Press “Apply” button



Select “Stored Printer Settings” tab in driver



With printer ON, select “Read” button to load current

printer settings



Under “Mark Type”, set to “Black Mark” or “Hole/Silicon”



Enter Ticket Length (C) and Top of Mark (D) measurements



If the printer does NOT have a presenter, the Presenter
Mode will be grayed out and blank



Select “Update” button, wait until loading is complete

FOR USING A TICKET WITH BLACK MARK/HOLE

Summary of Contents for ITK1 G Series

Page 1: ...G Properties driver utility Select General tab Select Preferences Select preferred orientation then select Advanced button Under Paper Size select correct ticket size press OK Press Apply button Selec...

Page 2: ...window ADDITIONAL NOTES Check that Preference Settings in application document are set to the correct ticket size as this setting could override Driver paper size setting If the low paper sensor is i...

Page 3: ...screen if highlighted Select Stored Printer Settings tab Select Read button to load current printer settings Set Mark Type to Continuous If the printer does NOT have a presenter the Presenter Mode wil...

Page 4: ...fed through presenter and held if not taken disposition is then dictated by selection of options in PRESENTER tab DO NOT select this option if using thicker fan fold ticket stock Select Update button...