Needle Nose Pliers
Awl
Grease
Screw Cement
Round Cutter & Sander
Sharp Hobby Knife
Hex Wrench
1.5mm
2.0mm
Ball Differential Grease
Ware Cutters
SP Knife Edge Reamer
Cross Wrench
For trimming bodies Cutting
along curved lines was never
so easy!
Do not pre-drill as precise
drilling of 1mm to 15mm
holes can be performed after
body shell painted.
A new battery must be charged before it is used. Refer to the charger instruction manual for charging.
Set up the radio control system as indicated below.
Battery
Transmitter
Off
On
Charger
Eletronic Speed
Controller
Receiver
Servo
Install batteries.(Transmitter)
Extend the antenna.(Transmitter)
Connect the battery to the ESC.
Extend the antenna.(Receiver)
Switch on both the transmitter and receiver.
Make sure the servos are in command.
Switch off both the transmitter
and receiver.
Retract the antrnna.
(Transmitter)
Center the trims.
Off
On
Off
On
TOOLS REQUIRED
RADIO PREPARATION
