3/12
Theatre Master manual.doc
The following points are important for safety as well as for the smooth
installation and performance of the unit.
When unpacking and before disposing of the package check there is no transportation damage before
using the projector. Should there be any damage caused by transportation, consult your dealer and do
not use the apparatus. Keep the package well for your possible future transportation.
The projector is for indoor use only, IP 20. Use only in dry locations. Keep this device away from rain
and moisture, excessive heat, humidity and dust. Do not allow contact with water or any other fluids, or
metallic objects.
The projector is not designed or intended to be mounted directly on to inflammable surfaces.
The projector is only intended for installation, operation and maintenance by qualified personnel.
The projector must be installed in a location with adequate ventilation, at least 50cm from adjacent
surfaces. Be sure that all the cooling fans run normally and no ventilation slots are blocked.
Do not project the beam onto inflammable surfaces, minimum distance is 3m.
3m
Avoid direct exposure to the light from the lamp. The light is harmful to the eye.
Do not attempt to dismantle and / or modify the projector in any way.
Electrical connection must only be carried out by qualified personnel.
Before installation, ensure that the voltage and frequency of power supply match the power
requirements of the projector. Only use the lamp with the specified type and rating.
It is essential that each projector is correctly earthed and that electrical installation conforms to all
relevant standards.
Do not connect this device to any dimmer pack.
Make sure that the power-cord is never crimped or damaged by sharp edges. Never let the power-cord
come into contact with other cables. Only handle the power-cord by the plug. Never pull out the plug
by tugging the power-cord.
Keep the lamp clean. Do not touch the lamp glass with bare hand.
The lamp used in this projector is an high power discharge lamp. After being switched off don’
t attempt
to restart the projector until lamp has cooled, this will require approx 15 minutes. Switching the lamp on
and off at short intervals will reduce the life of both the lamp and the projector. Occasional breaks will
prolong the life of both the lamp and the projector.
Never run the projector without a lamp.
There are no user serviceable parts inside the projector, do not open the housing and never operate
the projector with the covers removed.
Always disconnect from the mains, when the device is not in use or before cleaning it
or before attempting any maintenance work.
If you have any questions, don’
t hesitate to consult your dealer or manufacturer.
SAFE USAGE OF THE PROJECTOR
