8
Lock the tilt and unfasten 6 fast fit screws in the front cove. Open the cover and you’ll see the structures as the figures above.
For the replacement of color filters, use the fingers to remove the filters and place new ones.
For the rotating gobos: remove the rotator by hand; remove the gobo after the tightening spring for the gobo is taken out. Place a new
gobo in the rotator and put back the spring. And ensure the spring is into the narrow end of the rotator, i.e., inner ring of the rotator. At
last, use a proper tool to pull the tightening clip and put the rotator back to the wheel with the help of the other hand.
Note: Do not touch the color filters ,glass gobos with bare hand. There must be soft and clean paper or cloth between the hand and the
glass gobo. Tighten the 6 fast fit screws after the cover is put back. Unlock the Tilt.
DANGER!
BEFORE THE REPLACEMENT OF GOBO AND COLOR FILTER, THE PROJECTOR MUST BE OFF
POWER.
5. SETUP AND CONFIGURATION
●
FRONT PANEL OPERATION
The configuration and start address can be set conveniently via push button and color touch screen.
To view or change its setup, touch any white area of the screen or push the key OK for more than 3 seconds to unlock the
display(While only on battery, push OK key). After the unlocking, push
►
key t
o enter into function menus. Each main menu has its
Rotating gobo wheel 1
Color wheel
Rotating gobo wheel 2
Summary of Contents for PR-8170A
Page 25: ...25 ...
