9
图案片安装
滤色片安装
1
1
2
2
Lock the tilt and loosen the 4 fast-fit screws on the upper cover ,After removing the cover, you will see the structures as the figure above.
To replace a gobo on the rotating gobo wheel: take the rotator from the wheel in the sequence of
1→2
, take the gobo out from the rotator
by removing the tightening spring. Put the new gobo back to the rotator, then tighten it with the spring. Please ensure the spring is in the
narrow location of the rotator, which is the internal ring of it and flatten it. At last, pull up the spring strip using proper tool and put the
rotator back to the wheel with the assistance by another hand. Its installation is of the opposite sequence of removal(
（
2→1
）
.
Installation of gobos
NOTE
: Do not touch the glass gobo with bare hand. Place clean and soft paper or cloth between hand and glass gobos.
Tighten 4 hexagon screws after the cover is on. Unlock the tilt.
●
FIXING THE FRAMING MODULE
Remove the small cover after locking Tilt after adjusting the framing blades. Unplug the plug on the left after tightening the
screw against the module till it can’t move . At last, install the small cover.
If the framing blades need to be adjusted, plug the plug into its original place after loosening the tightening screw, then repeat
Step 1.
DANGER!
BEFORE REPLACEMENT OF GOBOS/COLOR FILTERS, A PROJECTOR MUST BE OFF THE POWER!
Plug
Tightening screw for
module rotation
