PR Lighting PR-2130, Instruction Manual

Page: 5 / 20

5/20
FITTING THE LAMP
Lock the yoke before fitting/replacing the lamp just as Shown by Figure 2, after Opening the head’s cover of a projector by loosening
4fastfit screws.
Pull out the lamp from the bottom of the head after rotating it anti-clockwise after holding the lamp’s bottom.
Installation and removal are in reverse orders.
Tighten the 4 fastfit screws after the cover is installed.
Note: don’t touch the bulb of the new lamp with bare hands so as not to impair the beam output.
Important: Always read "Instructions for use" enclosed with the lamp.
1.Manually loosen the 2 spring screws
2.Take the lamp out after pushing
it down after loosening the 2
spring screws
PR-2133
XR 130 Beam
DMX