PR Lighting PR-2001L, Quick Start Manual

Page: 5 / 14

When the power is switched on, the apparatus automatically starts to run the programmes of self
test. After finishing these, the apparatus is ready for operation.
Remove the cover of the control panel, you will see the DIP switches with numbers from 1 to 4,
and 3 rotary DIP switches for setting the start address and an LED display as shown in the figure
below.
That the status LED is on means there is a DMX signal receiving, and that the status LED is off
means there is not any DMX signal receiving.
Press the RESET button to reset the DMX start address and functions, and the status LED will
flash.
AUTO PROGRAMMES TABLE
In stand-alone and master/slave mode, by setting the 2 rotary DIP switches as shown in the
following table, the unit will run whichever of the 15 programmes that have been set.
TENS UNITS PROGRAMS FUNCTIONS
0 1 1 Slow change colours from red to magenta to yellow
0 2 2 Slow change colours from red to magenta to yellow to white
0 3 3 Slow change colours from green to cyan to yellow
0 4 4 Slow change colours from green to cyan to yellow to white
0 5 5 Slow change colours from blue to cyan to magenta
0 6 6 Slow change colours from blue to cyan to magenta white
0 7 7 Slow change all colours in sequence
0 8 8 Slow change all colours and white in sequence
0 9 9 Medium-speed change all colours
1 0 10 Medium-speed change all colours and white in sequence
1 1 11 Medium to fast change all colours and white in sequence
1 2 12 Medium to fast change all colours in sequence
1 3 13 Fast change all colours and white in sequence
1 4 14 Basic colours (in 6 seconds)
1 5 15 Basic colours and white (in 6 seconds)
5/14