Position the projector-head in vertical position and lock it via locking knob.
Remove the projector-head cover by loosening the 4 retaining-clips.
Open the dichroic-colour-filter bracket by undoing the 2 M4 knurled-screws.
Insert the lamp in the lamp-holder, and ensure the little bubble on the lamp is at a right angle (90°)
to the beam path. Keep the lamp clean during installation.
Tighten the 2 M3 lamp fixing screws only manually.
Close the dichroic-colour-filter bracket and install projector-head cover. Make sure that all screws
and retaining-clips are tightened.
Note:
The MSI series are high pressure lamps with external igniters ( ). Care should always be
taken when handling these lamps. Always read the manufacturers "Instructions for use" enclosed
with the lamp.
Use the plug provided to connect the mains power to the projector paying attention to
the voltage
and frequency marked on the panel of the projector. It is recommended that each projector is
supplied separately so that they may be individually switched on and off. It is recommended that
the projector connect to the mains using a 3-pin 16A plug.
4/14
Summary of Contents for PR-2001L
Page 12: ...12 14...
