PR Lighting AQUA LED 3000-W FRAMING, Manual

Page: 4 / 32

4
electrical parts’ life will be shortened .
●
There are safety cord holes at the bottom of the base of a projector. In view of safety, please run the safety cord
supplied through the safety cord holes for safety support.
●
Before any installation, maintenance and cleaning work, please ensure the projector is disconnected from power
mains.
●
.After stable operation under normal ambient temperature ,the temperature of the external surface of the housing
of a projector(the surface of the heat sink) is
80
℃
after the stable running.
●
While the lamp is stricken for the first time, there will be smoke and strange smell. It’s normal and does not
mean the projector has some defects.
●
While the projector running, don not touch the metallic housing to avoid being burned.
●
Do not mount the projector directly on inflammable surface.
●
Do not project the beam straightly on combustible items and the minimum distance between the projector
and illuminated items is 5m.
●
A projector should be installed with good ventilation and the minimum distance between the projector and
walls is 50cm. At the same time, please ensure the fans and air inlets and outlets are workable.
●
Do not let the front lens exposed to sunlight or other strong light sources at any angle, otherwise beam focused
inside via the front lens can result in fire.
●
The product meets The General Technical Requirements and Standards for Recycle and Use Of Expired
Appliance and Electronic Products.
●
When the product meets disposal standards and needs to be disposed, a client needs to dispose and recycle it.
2.
INSTRUCTIONS
●
CLEANING AND MAINTENANCE
If a projector can’t start. Please check if the fuse is blown up. If it does, replace it with a new fuse with same ratings. And the
projector has over-temperature protective device. If the temperature is too high, the protective device will be triggered to shut the
projector off. When it happens, please check if the fans run normally or fan shield is blocked by dust. After the issue is solved,
restart the projector.
The accumulation of oil, smoke and dust on the lens, heat sink and fans will compromise the light output. Cleaning a projector is
very necessary to ensure a reliable use of it.
The cleaning frequency of cooling fans and heat sink is decided by the operations, environment and climate. It is advised to clean
it every 15days or less . Use rubber or bush or other non- metallic tools to carry out cleaning. The tools can’t scratch or deform the
heat sink and fans.
Cleaning frequency is to be decided by operations and its environment. Use soft cloth and normal detergent for glass for cleaning
work. It’s advised external optical system be cleaned every 20days. Keep lens clean and do not touch optical parts with bare
hands.
SPECIAL NOTE:
It’s normal phenomena that there will be mild water mist on the lens while the waterproof product is in use.