PR Lighting AQUA 350 BEAM, Manual

Page: 5 / 26

5
To ensure smooth movement of gobos and focus lens, it’s advised rotators’ bearings and 2 sliding bars for focus lens be lubricated
every 2 months. High quality and high temperature lubricant/grease is advised..
●
TROUBLESHOOTING
PROBLEM ACTION
The projector doesn’t switch on

Check the fuse on the power socket.

Check the lamp.
The lamp is on but the projector doesn’t respond
to the controller

Make sure that the fixture’s start address is right

Replace or repair the XLR signal cable.
The projector functions intermittently

Make sure the fan is working well or fans and their shields are not blocked
Beam appears dim, Low in brightness

Make sure the lamp is within its lifespan

Remove dust or grease from the lenses.
The project image appears to have a halo

Carefully clean the lamp, optical lenses and other components.
Heavily Defective Beam

Check if lens are in good condition(not cracked)

Clean dust or grease on the lens.
3. APPEARANCE
1. Front Glass
2. Waterproof Front Cover
3. Waterproof Back Cover
4. Airflow Cover
5. Arm Cover
6. Handle
Rear Panel of the Base
1.Waterproof Power Socket
2.5-Pin Waterproof XLR Socket(Male)
3.5-Pin Waterproof XLR Socket(Female)
4.Waterproof Wireless Receiver
Front Panel of the Base
1.Escape Key
2.Up Key
3.Down Key
4.Enter Key