PR Lighting AQUA 350 BEAM, Manual

Page: 10 / 26

10
●
STAND-ALONE MODE
Operate the projector without connecting with a controller, enable the master mode through the operation panel, the
projector will run in Stand-Alone mode automatically.
DMX address can be set at any number within 512
.
●
MASTER/SLAVE MODE
Many projectors can run synchronously in the Master/Slave mode by linking them with each other. First,
connect the first fixture’s DMX output to the second fixture’s DMX input using XLR-XLR control cable and then connect the second
fixture’s DMX output to the third fixture’s DMX input, and so on until all projector are connected in this way. Eventually connect the
last fixture’s DMX output to a DMX terminator. Set 1
st
projector as the master and others are Slaves.
Start Addresses of all Slaves are 001; Operation mode of the Master can be set any mode for a Master’ and Slaves’ operation mode can
be set accordingly.
After Powered on, the group will run in Master/Slave Mode
6. OPERATION MENU
1st
LEVEL
2nd LEVEL 3rd LEVEL 4th LEVEL 5th LEVEL
Address
DMX Address
1-496(Short Mode)
1-492(Standard Mode)
1-491(Extend Mode)
Reset
Total Reset
Really Reset?
Confirm or Cancel
Pan&Tilt Reset
Really Reset?
Confirm or Cancel
Colour System Reset
Really Reset?
Confirm or Cancel
Gobo Reset
Really Reset?
Confirm or Cancel
Dimmer/Strobe reset
Really Reset?
Confirm or Cancel
Fo. Ef. Pr. Reset
Really Reset?
Confirm or Cancel
OUTPUT TERMINATOR INPUT OUTPUT INPUT
MASTER SLAVE SLAVE