Wall Mount with a 7 Axis Extendable Arm + Enhanced VESA 75-100mm Screen Pan and Tilt Head
PN’s 80005, 80005-3036 & 80005-3642
5
WWW.PRACTICALQUALITYSYSTEMS.COM
(818) 993-1022
ALL PRODUCTS PATENT PENDING
Single Position 25lb Wall Mounting Plate with Integral Standoff bracket, Offset Arm Bracket and Arm
•
The Single Position 25lb Wall Mounting Plate with Integral Standoff bracket supports one arm, allows
side to side adjustment of the arm, and attaches to any flat, smooth vertical surface.
•
Attach the mounting plate to a wall or other flat vertical surface with appropriate fasteners.
•
The side-to-
side pan position resistance is preset at the factory with a 5/16” bolt in the center of the
upper standoff plate allowing the arm offset bracket to move freely side to side and should not need
adjustment. However, a ½” wrench can be used to adjust the tension on this bolt.
•
To permanently lock the side-to-side position of the offset bracket and arm: Loosen the 10-32 Phillips
head screw on the top of the standoff bracket, adjust the side-to-side position of the offset bracket and
arm, tighten the screw into one of the holes in the offset bracket to secure the new position.
•
The offset bracket attaches the arm to the standoff bracket and allows adjustment of the up and down
“offset angle” of the arm.
•
Adjusting the up and down posi
tion of the arm at the offset bracket: Remove the 1/4” wire-lock clevis
pin from the offset bracket to adjust the up and down position of the arm, then reinsert the pin into one
of the holes in the offset bracket and through the arm to secure the new position.
•
Note that the mounting plate includes slots along the sides so that it can be attached to poles up to 36”
in diameter with our optional strapping kit PN 80801 or any other compatible hose clamps.
•
The mounting plate includes multiple slots for cable tie points.
