22
User Manual
zenex
4800
9600
1200
2400
(Default : 9600)
Parameter Description
Settings
Default Value
PERMISSION FOR OP2/OP3 SETPOINT EDITING
ON OPERATOR PAGE
This parameter allows the user to enable (permit) or disable
(restrict) the adjustment of the Setpoint for OP2 / OP3 functions.
SOAK ABORT COMMAND ON
OPERATOR PAGE
This parameter allows the user to enable (permit) or disable
(restrict) the issuance of ‘Abort’ command from operator page to
Abort (Stop) the running Soak Timer.
SOAK TIME ADJUSTMENT ON
OPERATOR PAGE
This parameter allows the user to enable (permit) or disable
(restrict) the adjustment of the ‘Soak Time Duration’ on Operator
Page.
UTILITY OPTION
None
No optional utility module is fitted / functional.
Serial Communication
The optional utility module is RS485/RS232 serial communication
port.
Soak Start
The optional utility module is Digital Input (potential-free contact
closure) for Soak Start Command. An open to close contact will
initiate the Soak Timer.
(The following parameters are available and applicable for utility
option serial communication)
Serial Comm.
None
Soak Start
(Default :
None)
SLAVE ID
This parameter assigns a unique identification number that the
Master Device can use to address the instrument for any
communication data transactions. The settable values are from 1
to 127.
1 to 127
(Default :
1)
BAUD RATE
This parameter defines the communication speed expressed in
“Bits per second”. The Baud Rate must be set to match the Baud
Rate set for the Master Device.
Enable
Disable
(Default :
Enable)
Enable
Disable
(Default :
Enable)
Enable
Disable
(Default :
Enable)
