23
User Manual
Zenex Pro
Parameter Description
Settings
Default Value
PERMISSION FOR OP2/OP3 SETPOINT EDITING
ON OPERATOR PAGE
This parameter allows the user to enable (permit) or disable
(restrict) the adjustment of the Setpoint for OP2 / OP3 functions.
SOAK ABORT COMMAND ON
OPERATOR PAGE
This parameter allows the user to enable (permit) or disable
(restrict) the issuance of ‘Abort’ command from operator page to
Abort (Stop) the running Soak Timer.
SOAK TIME ADJUSTMENT ON
OPERATOR PAGE
This parameter allows the user to enable (permit) or disable
(restrict) the adjustment of the ‘Soak Time Duration’ on Operator
Page.
UTILITY OPTION
This parameter assigns one of the following functions to the Digital
Input.
None
Digital Input is unused.
Soak Start
Digital Input is used for issuing Soak Timer Start Command. An
open to close contact will initiate the Soak Timer.
Water Level Low
Digital Input is used for detecting Low Water Level.
SLAVE ID
This parameter assigns a unique identification number that the
Master Device can use to address the instrument for any
communication data transactions. The settable values are from 1
to 127.
1 to 127
(Default : 1)
BAUD RATE
This parameter defines the communication speed expressed in
“Bits per second”. The Baud Rate must be set to match the Baud
Rate set for the Master Device.
(Default : 9600)
4800
9600
19200
WATER LEVEL-LOW DETECTION LOGIC
This parameter is available if Digital Input is used for Low Water
Level Detection. Set to ‘Open’ or ‘Close’ depending upon whether
contact-open
or
contact-close
means
water low
detection.
(Default :
None)
None (Unused)
Water Level Low Detection
Soak Start Command
(Default : Open)
Open
Close
Enable
Disable
(Default :
Enable)
Enable
Disable
(Default :
Enable)
Enable
Disable
(Default :
Enable)
