13
Reverse
Normal
(Default : Reverse)
°C
°F
(Default : C)
°
Relay
SSR
0 - 20 mA
4 - 20 mA
0 - 5 V
0 - 10 V
(Default : Relay)
PV RANGE LOW
( Available for DC Linear Inputs)
Sets process value corresponding to minimum DC Linear signal
input (e.g., 0 V, 0 mA, 4 mA, etc.)
PV UNITS
(Available for Thermocouple / RTD Inputs)
Selects temperature measurement units in °C or °F .
PV RESOLUTION
(Not Available for Thermocouple Inputs)
Sets the process value indication resolution (decimal point). All
the resolution based parameters (control setpoint, hysteresis,
alarm setpoints etc.) then follow this resolution setting.
INPUT TYPE
Select Input type in accordance with the type of Thermocouple or
RTD sensor or transducer output connected for process value
measurement. Ensure proper hardware jumper settings.
CONTROL LOGIC
Select Reverse (
heat
logic) or Direct (
cool
logic).
CONTROL ACTION
Select appropriate Control Algorithm suited for process
requirement.
CONTROL OUTPUT (OP1) TYPE
Select the output type in accordance with the hardware
configuration for Output-1 (OP1).
Refer Table 6.2
(Default : 1)
Pulse
On-Off
PID
(Default : PID)
Parameter Description
Settings
(Default Value)
-1999 to 9999
(Default : 0)
Refer Table 6.2
(Default : Type K)
Table 6.1
CONFIGURATION PARAMETERS
The controller is provided with a variety of hardware options and software features to cater to a host of applications. The
controller thus needs to be appropriately configured in terms of inputs / outputs and other features like control algorithm, digital
filter, etc.
The PAGE-12 presents configuration parameters that are listed below in Table 6.1 .
User Manual
EPSILON
Section 6
