Property of
www.ppgplans.com
– Do not duplicate or make public.
Last Revised Version: January 2010
© PPGPlans.com
5)
Now you can remove the connector from the side radial tube, place it on the lower hoop tube
where you traced around it, use a center punch through the center of the connector to mark
the tube. Drill a 7/32 hole on this mark through one wall of the tube only and bolt the
connector to the tube using the half round anchor inside of the tube. This is where is
hemostat comes in handy to hold the nut inside of the tube.
Repeat these procedures for the other lower hoop tube. Then use the same procedures for
installing the connectors to the 0.750 hoop section, being sure they slide into the lower sections