8
9
INSTALLING THE AUTOMATIC BARRIER
1.
When anchoring the cubicle, note that its inspection door must face the
side of the track or traffic lane.
2. Position / align the cubicle on the concrete plinth and mark the places
where the holes will be drilled, so that the front of the automatic barrier
(inspection door side) is located towards the curb (street, traffic lane).
3. Remove the cubicle from the plinth and drill the holes in the previously
marked locations.
Note:
Drill 04 holes with a Ø10mm drill and at least 80mm (3.2 in) deep.
4. Insert the anchor bolts into the holes in the concrete plinth, as indicated
below.
Note:
The anchor bolts must not be inserted completely, they must remain
about 15mm (0.6 in) out of the concrete plinth.
5.
Position the cubicle on the concrete plinth, fitting the holes of the cubicle
in the anchor bolts.
6. Check the cubicle alignment again. If necessary, move it in a circular
manner as desired.
INSPECTION DOOR
ANCHOR BOLTS
VEHICLE FL
OW DIREC
TION
