page no. 5 of 28
PZN Aquamatic Water Heater
Doc Ref M107 issue 1.3 Sep 2018.
Water-fed fan heaters are designed to provide heating in
winter and ventilation in summer.
The unit is designed to be suspended from suitable
roof points or alternatively to be mounted on purpose
designed brackets and are intended primarily for
commercial or industrial premises.
Hot water produced by the boiler/heat pump (not suppled)
flows through the high efficiency copper heat exchanger.
A high performance axial fan on the rear of the unit blows
ambient air across the warm heat exchanger, increasing
the output temperature.
The fan has the capability of running at three speeds
when used in conjunction with the optional variable speed
switch.
During the summer the fan can be run on its own to
provide ventilation.
IMPORTANT
Service and Maintenance Engineers shall
ensure that replacement items are fitted,
adjusted and set in accordance with the
data and detail set out in these instructions. If in doubt
consult Powrmatic Technical Department.
• Bear in mind that if you use products powered
trough electric power, gas, etc., you should comply
with some basic rules, such as:
• This device cannot be used by people (including
children) with reduced physical, sensory or mental
abilities or lack of experience and knowledge, unless
they are supervised or trained on the use of the unit
by the person who is responsible for its safety.
• Do not touch the heater if you are barefoot or if parts
of your body are wet .
• Before carrying out any cleaning and/or maintenance
work on the unit always disconnect the unit from the
mains power supply by turning the main switch to
OFF.
• Any modification to safety or regulation systems
is strictly forbidden without the Manufacturer’s
permission and guidance.
• Do not pull, disconnect and twist the electrical cables
coming from the unit, even if it is disconnected from
the electrical power supply.
• Do not stand or sit on the unit and/or put any objects
on the unit.
• Do not abandon or leave available to children the
heater packing materials (cartons, nails, plastic bags
etc.), as these are a potential source of danger.
• Do not install the unit in areas with a damp or
“aggressive” atmosphere.
• Do not insert foreign objects through the grille in the
cover.
• Do not touch the heat exchanger battery with naked
hands.
• Do not use adapters, multiple sockets or extension
leads to connect the unit to the electricity supply.
• It is forbidden to install the unit outdoors or where it
is exposed to adverse weather conditions.
force when the product is marketed. The knowledge and
observance of the laws and standards regarding plant
design, installation, operation and maintenance are the
sole responsibility of the designer, installer and user.
The manufacturer shall not be held responsible for
failure to comply with the instructions of this manual,
for the consequences of any operations carried out and
not specifically provided for or for translations open to
misinterpretation.