10
Pow’R’kraft Chipper 10
Revision 9/22/16
Discharge Chute
Wood Chipper Operation
Adding fuel
Fill the fuel tank as instructed in the separate
Engine Manual packed with the machine.
Disengaging the belt drive
For easy starting of the engine, disengage the
belt drive by pushing the lever at the back of
the housing down.
Starting engine
1. Move the fuel valve lever to the ON position.
2. To start a cold engine, move the choke to
the CLOSE position.To restart a warm engine,
leave the choke leverin the OPEN position.
3. Move the throttle lever to the halfway
position.
4. Turn the engine switch to the ON position.
5. Operate the starter.
Recoil Starter
Pull the starter grip lightly until you feel
resistance,then pull briskly, return the starter
grip gently.
If the choke lever has been moved to the
CLOSE position to start the engine, gradually
move it to the open position as the engine
warms up.
Fill tank to no more than 12.5mm
(1/2”) below the bottom of the
filler neck to provide space for
expansion.
Chipped materials are discharged through
this opening. Deflector can be attached to the
chute.
Transport Wheels
To move the wood chipper, grip the handles
to tilt the machine slightly for next location.
Belt Tension Lever
It is at the back of the housing. Pull it up to
engage the belt drive and run the cutting disk.
Push it down to disengage the belt drive and
stop the cutting disk.
Deflector Lever
Loosen it in the anti-clockwise direction
to adjust discharge angle. Tighten it in the
clockwise direction.
Operating
After engine warms up, pull throttle lever
toaccelerate engine speed.
IMPORTANT: Allow the engine to
run with no load until warm (1-5
minutes) after each start-up to
stabilize.
