5
Daily Operation and Maintenance
How to Install Batteries
Caution: Batteries are heavy.
Install (2) 12-volt deep cycle batteries. New Batteries should be given a full charge before first use.
1. Unplug the hoses (20, 21) from the recovery tank (19).
2. Make sure the recovery tank is empty then lift it up.
3. Place batteries on the tray. Use the bracket to secure them. Position them correctly.
4. Connect all the cable terminals.
Caution: Make sure you connect RED (+) cable terminals to positive (+) posts and BLACK (-) cable terminals
to negative (-) posts. Machine will not operate if not connected properly. Failure to do so will result in
damage to batteries and possible explosion.
Spray each post with a protective lubricant. Place battery terminal protectors over all posts.
How to Charge the Batteries
Caution: Only use a battery charger designed for the machine. Failure to do so can result in damage to the
batteries.
Remove the recovery tank from machine and disconnect anderson plug from the control planel. Next connect the
charging plug to the anderson plug connected to the battery terminal. Plug the other charger plug to wall outlet. The
charger will automatically begin to charge the batteries.
How to Install the Squeegee
1. Put squeegee Release Handle (3) in the UP and locked position.
2. Position the squeegee blade assembly on the swing arm. Make sure the guide wheels face the rear of the
squeegee.
3. Hand tighten the 2 thumb screw (6).
4. Place the solution recovery hose (20) over the nozzle. Make sure it fits tight.
How to Install Pad Holder and Brush
1. Raise the brush pad by stepping on Brush Lift Pedal (4) at the rear of the machine.
2. With the pad holder/brush (14) in lifted position, insert it into the plate underneath by turning it counter-clockwise
until it locks.
How to Fill the Solution Tank
1. Open the solution fill cover (17).
2. Fill the tank (16) with the desired level of clean water.
3. Add cleaning chemical.
Do not overfill.
