S
PORT
F
ISHING
450
A
NCHOR
W
INCH
P
OWERWINCH
8
T
ESTING THE
U
NIT
1.
Ensure that all connections are secure and correct. For the 46' make sure that the
in-line fuse is installed in the Red wire between the switch and relay module.
2.
Without rope or chain in gypsy, press and hold switch in upward position. If
wiring to switch terminals is correct, gypsy will spin counterclockwise.
If gypsy does not turn, but motor runs, switch is incorrectly wired. To
correct, switch the black and white wires on back of the switch.
L
OADING THE
R
OPE AND
C
HAIN
R
ODE
(Refer to the rope and chain requirements on page 3.)
1.
Feed rope through davit or bow roller and pull toward anchor winch. Make sure
rope is not twisted or kinked and can freely run through bow roller or davit.
2.
Lift finger and insert rope into rode glide and down into rope locker. Allow
enough slack so rope can be tied off in rope locker.
3.
Release finger and make sure rope is firmly seated in the gypsy.
4.
Go below to rope locker and tie rope off.
5.
Press switch up and begin retrieving rope and chain into rope locker.
