11 - ENG
G. handle
h. frame
I. pump Outlet
J. pump Inlet
bASIC ELEMENTS Of AN ENGINE
Refer to the engine manual for location
and operation of engine controls.
Choke Control:
Opens and closes
carburetor choke valve.
Starter Grip:
Pulling starter grip
operates recoil starter to crank engine.
Engine Switch:
Enables and disables
ignition system.
ASSEmbLY
INSTrUcTIONS (FIG. 1– 4)
1. Locate and remove all loose parts
from the carton.
2. Cut four corners of the carton from
top to bottom and lay the panels
flat.
3. Place handle onto frame and secure
with saddle bolt (K) and knob (L).
G
h
K
L
2
CAUTION: Risk of personal injury.
Avoid placing hands between handle
and frame when assembling to
prevent pinching.
4. Connect wand (E) to gun (D).
Tighten securely.
3
5. Attach
high
4
pressure hose (C)
to gun (D). Tighten
se cure ly.
NOTE:
The pump on this unit is
maintenance free and requires no oil.
If there is a problem with the pump,
contact our Customer Service Group
on www.power-washer.us as soon as
possible.
NOTICE:
The engine is shipped
without oil. Before starting engine, add
the oil provided. Damage to the engine
will occur if the engine is ran without
oil, this damage will not be covered
under warranty.
OpErATION
pRESSURE WAShER
TERMINOLOGY
pSI:
Pounds per Square Inch. The unit of
measure for water pressure. Also used
for air pressure, hydraulic pressure, etc.
Sometimes noted as “Bar”, another unit
of measure.
GpM:
Gallons per Minute. The unit of
measure for the flow rate of water.
CU:
Cleaning Units. GPM multiplied by
psi equals CU.
bypass Mode:
Allows water to
re-circulate within the pump when the
gun trigger is not pulled. This feature
allows the operator to release the
trigger gun and reposition themselves
without having to turn the engine off in
between cleaning actions.
NOTICE:
Allowing the unit to run for
more than two minutes without the
gun trigger being pulled could cause
overheating and damage to the pump.
Do not let the pressure washer run
for more than two minutes in Bypass
Mode. Turn off the engine and relieve
the pressure in the gun during these
extended situations.
