Powervar ACE Series, User Manual

Page: 13 / 44

ACE Series Rack-Mount • 05145651A 5
Figure 2. Attaching the Mounting Bracket
Installing the UPS
Follow these steps to install your UPS. Figure 3 shows a typical
installation; installing your specific model may vary. Appendix C
shows the rear panel of each model.
NOTE
Some units may not recognize 50 Hz outlets. If you connect your UPS to a
50 Hz
outlet, and it will not
start, press the ON button for 3 seconds to start the UPS on battery. Then configure the UPS input voltage
for either 100 V or 110 V (see Section 3, Configuration). The UPS recognizes the input line and goes off
battery.
CAUTION
DO NOT plug laser printers into a UPS. The high surge currents they produce can disrupt any manufacturer’s
UPS.
NOTE
œ
If your UPS output receptacles are divided into Load Segments, and you plan to take advantage of this
feature (available only with specific power management software), read the appropriate sections of
your power management software manual before you install the UPS.
œ
Changes or modifications not expressly approved by the party responsible for compliance could void your
authority to operate the equipment.