PowerTek 9010, User Manual

Page: 19 / 75

1. Connect the voltmeter to the calibrator as shown on the figure below.
2. Select appropriate function and range on the voltmeter
3. Push VOLTAGE function key on the calibrator. DC mode is automatically set. Push VOLTAGE
key once more if AC voltage is requested.
4. In AC mode push SELECT function repeatedly to activate window Frequency and set requested
frequency.
5. Set output voltage value using cursor keys, rotary button or numerical keyboard.
6. Switch output terminals on by pushing key OPER. Output voltage is presented on the output
terminals, OPER key is lit and indication SOURCE on the screen is green.
7. Push STBY key to switch output off.
Calibrator can source non-sinusoidal waveforms with pre-defined shape. Output is limited to 200 V and
1 kHz. Following waveforms are implemented:
- Limit. Sine sinusoidal with defined distortion 13.22 %
- Square squarewave symmetrical
- Triangle symmetrical
- Ramp Up
- Ramp Down
- Harmonic
adjustable harmonic products
To select requested waveform push the soft key SHAPE, highlight requested item using softkeys

,
cursor keys or rotary button and confirm with ENTER.
Terminals
HI
LO
I+
I-
HIR GND
Entry
Function
TRG HF
9010 Multifunction Calibrator
V COM A R
METER
SCOPE
SOURCE
METER
NULL
SELECT SETUP SYSTEM
1100V
RMS
MAX
1500V
DC
MAX
1V PK
MAX
20V PK
MAX
1 00V PK
MAX
10V PK
MAX
2V PK
MAX
25V PK
MAX
10V PK
MAX
50V PK MAX 50 V PK MAX
FUNC
OPER STBY
10V
RMS
MAX
Powertek MC9010 User Manual