3
ASSEMBLY
CAUTION:
Do not attempt assembly if parts are missing.
Use this manual to order replacement parts.
Do not operate this tool until completely assembled. Do
not operate this tool until you have completely read
and understood this manual.
MOUNT TABLE SAW
Refer to figure 2
• The table saw must be installed in a well-lighted area
with correct power supply.
• The table saw can be installed on either a workbench or
a tool stand by using bolts, lock washers, and hex nuts.
• The table saw must be bolted to a firm and level surface.
• There must be enough clearance for the moving
workpiece during operation and enough room for safety
operation of the machine.
Figure 2 shows the base dimension and mounting holes.
Figure 2
INSTALL THE BRACKET FOR THE PUSH
STICK
Refer to Figure 3
Secure the two brackets to the right-hand side of the saw
using the Phillips screw supplied.
Figure 3
RAISE AND LOWER THE SAW BLADE
Refer to Figure 4
1. Screw the crank handle into the hand wheel.
2. Turn the hand wheel clockwise to lower the blade and
turn the hand wheel counterclockwise to raise the blade.
Figure 4
TILT SAW BLADE
Refer to Figure 5
1. Loosen blade miter angle lock knob to tilt the saw
blade.
2. Slide the hand wheel without turning it until the blade is
at the desired angle.
3. Tighten the miter angle lock knob.
Figure 5
RIP FENCE
Refer to figure 6
1. Position the fence on the saw table.
2. Hook the rear steel clamp plate of fence over the back
edge of saw table.
3. Engage the lock head into the front groove of saw table.
Figure 6
4. Lift the fence lock hand and slide the fence to the
desired position. The rip fence is usually operated on
the right hand side of the table.
5. Push down the lock hand to secure the fence position.
6. Rotate knob clockwise to increase fence tension on the
saw table if necessary.
WARNING
Figure 3
Rear Steel Clamp
Lock Head
Brackets
Fence Handle
Miter Angle Lock Knob
Hand Wheel
Crank Handle
