12.
13.
www.powertec.net.nz
www.powertec.net.nz
PT2000i
DIGITAL INVERTER GENERATOR
Output Indicator (Green)
The AC Output Indicator (pilot light) comes
on when the engine starts and produces
power.
AC and DC Reset (Circuit Breakers)
The Circuit Breakers turn the generator
“OFF” automatically when an electrical de-
vice connected to the generator is operating
above the rated current. To use this equip-
ment again, turn on the Circuit Breaker by
pressing in its button to “ON”. If Circuit Break-
er cuts power out again, reduce the load of
the connected electric device below the
specified rated output of the generator and
press button in to “ON” again.
CAUTION!
If the Circuit Breaker continues to cut
out, stop using the device immediately
and consult your local authorised Pow-
ertec Service Provider.
ESC Throttle
(Engine Smart Control)
When the ESC switch is in the “ON” position
the smart throttle controls the engine speed
according to the connected electrical load.
The results are better fuel consumption and
less noise.
When the switch is in the “OFF” position the
engine runs at 4500rpm regardless of wheth-
er there is a load connected or not.
NOTE: The ESC switch must be turned to
“OFF” when using electrical devices that re-
quire a large starting current, such as a com-
pressor or a submergible pump.
Fuel Tank Cap
Remove the fuel tank cap by turning it anti-
clockwise.
Fuel Tank Cap Air Vent Knob
The fuel tank cap is provided with an air vent
knob to stop fuel flow. The air vent knob must
be turned to “ON”. This will allow fuel to flow
to the carburetor and the engine to run.
When the engine is not in use, turn the air
vent knob to “OFF” to stop fuel flow.
Fuel Tank
Cap
Air Knob
Generator Ground
Circuit (Earth)
The Earth terminal is used to
earth the generator when earthed
electrical devices are being used.
Consult an electrician for local
earthing regulations.
