PowerTec MT4009, Owner'S Manual

Page: 6 / 12

Attach the Lever Assembly
Refer to Figure 8–10
• Remove the bolt, washers, nut, large washer and spring
from the lever assembly (See Figure 10).
• Place the large washer and spring between the locking
mechanism and the welded bracket as shown in
Figure 8.
• Slide the lever through the holes in the frame, spring,
large washer and into the locking mechanism.
• Align the holes in the locking mechanism and the lever
assembly rod. Secure in place with bolt, washers and
nut as shown in Figure 10. Tighten nut.
Locking Mechanism
Figure 8
Large Washer
Spring
Welded Bracket
Lever
Assembly
Rod
Locking
Mechanism
Figure 9
Release Lever Rod
Holes
in
Frame
Nut
Locking Mechanism
Figure 10
Bolt
Washer
Washer
Lever
Assembly
Rod
Large Washer
Mounting the Saw
Refer to Figure 11
WARNING
Risk of accidental starting and serious personal injury.
Unplug the saw before attaching it to the saw stand.
WARNING
Risk of serious personal injury. Always make sure the saw
is fully supported and securely attached to a level work
surface. Make sure the table saw stand is located on a
flat surface.
NOTE:
There are two sets of mounting hardware, a
1-3/4" set for mounting to the table top and a 2-1/2" set
for mounting a larger saw directly to the frame using the
holes in the frame.
• Place the saw to be used on the table top.
• Move the saw around until the hole pattern matches
the slot combination on the table top, secure with the
mounting hardware (1-3/4" set) supplied.
• Insert the bolt through the bottom of the table and
secure with flat washer, lock washer and nut.
NOTE:
When mounting a larger saw directly to the
frame using the mounting hardware (2-1/2" set) supplied
ALWAYS insert the bolt through the bottom of the table
and secure with flat washer, lock washer and nut.
Figure 11
Holes in
Frame
Bolt
Lock
Washer
Nut
Flat
Washer
ASSEMBLY
4