PowerTec MT4009, Owner'S Manual

Page: 4 / 12

2
ASSEMBLY
ASSEMBLY
2
UNPACKING
Refer to Figure 1
Check for shipping damage. Check immediately that all
parts and accessories are included.
ITEM DESCRIPTION QTY
A Main Frame 1
B Footrest 1
C Feet 2
D Wheels 2
E Handle 2
F Lever Assembly 1
G Wheel Bolts M12x 80 (Wheel) 2
H Flat Washers (Wheel) 4
I Hex Locking Nut M12 (Wheel) 2
J Button Head Screws M8x40 (Footrest/
Handle) 8
K Hex Locking Nut M8 (Footrest/Handle) 8
L Saw Mounting Hardware - 1-3/4" set
(Mounting Bolt, Washer, Lock Washers
and Nut) 4
M Saw Mounting Hardware 2-1/2" set
(Mounting Bolt, Washer, Lock Washers
and Nut) 4
I
F
G
K
Figure 1
A
H
D
B
C
E
J
L M
WARNING
Do not use the table saw stand until it is completely
assembled and you have read and understood this entire
operating manual and the operating manual of the tool
being used with this table saw stand.
WARNING
Do not use the table saw stand for scaffolding or as a
ladder. Make sure to securely tighten all fasteners before
using. Maximum capacity is 331 lbs (150 kg).
TOOLS NEEDED
The following tools (not included) are needed to assemble
the table saw stand:
1 - 13 mm wrench (Footrest, Handle Assembly and 1-3/4"
Mounting Hardware)
1 - 5 mm wrench (Footrest, Handle Assembly and 2-1/2"
Mounting Hardware)
1 - 8 mm wrench (Lever Assembly)
2 - 19 mm wrench (Footrest, Wheels Assembly)
1 - 8 mm wrench (Footrest, Wheels Assembly)
1 - Phillips screw driver (Lever Assembly)
ASSEMBLY
Unfold the Main Frame
Refer to Figure 2–3
• Push locking mechanism down and unfold the main
frame as shown in Figures 2–3.
Figure 2
Main Frame
Locking
Mechanism
Main Frame
Figure 3