PowerTec MT4006, Owner'S Manual, Page: 4 / 8

2
ASSEMBLY
ASSEMBLY
2
UNPACKING
Refer to Figure 1
Check for shipping damage. Check immediately whether
all parts and accessories are included.
ITEM DESCRIPTION QTY
A Folding Leg Assemblies 2
B Table Top Boards 2
C Crossbars 2
D Crank Assemblies 2
E Bolts M8 (Crank to Leg Assembly) 4
F Nuts M8 (Crank to Leg Assembly) 4
G Washers M8 (Crank to Leg Assembly) 8
H Screws M6 (Crossbar to Leg Assembly) 8
I Washers M6 (Crossbar to Leg Assembly) 8
J Nuts M6 (Crossbar to Leg Assembly) 8
K Wood Screws
(Top Boards to Crank Assy.) 16
L Wrench 10/13 1
M Rubber Feet 4
N Bench Dogs 4
10
13
A
B
F
C
H
G
I
K
L
M
N
J
Figure 1
D
E
WARNING
Do not use the work bench until it is completely
assembled and you have read and understood this entire
operating manual.
WARNING
Do not use the work bench for scaffolding or as a ladder.
Make sure to securely tighten all fasteners before using.
Maximum capacity is 220 lbs (100 kg).
TOOLS NEEDED
The following tools are needed to assemble the
work bench:
Phillips screwdriver (not included)
10/13 wrench (included)
ASSEMBLY
Refer to Figure 2-6
• Unfold the folding leg assemblies.
• Assemble the crossbars to the folding leg assemblies.
Align holes in leg and crossbar, insert screw into the
front of leg, through crossbar and secure with washer
and nut. Tighten all hardware.
IMPORTANT: The folded leg assemblies flare out
slightly to provide stability to the work bench. The
flared legs MUST be oriented to face the outside.
Figure 2
Flared Leg to
the outside
Crossbar
Crossbar
Screw
Washer
Nut
• Assemble the crank assemblies to the table top boards.
Place the table top boards face down and flush against
each other, make sure the notches are to the inside and
the ruler faces the outside.
• Place the crank assemblies onto the table top boards
and orient the cranks to the side of the table top with
the ruler.
• Align pre-drilled holes in front (ruler side) table top board
with holes in brackets on the crank assembly. Secure in
place with wood screws.
• Keeping the table top boards flush against each other,
turn the crank (if needed) to align the bracket holes with
the pre-drilled holes in second table top board. When
aligned, secure in place with wood screws.