INSTALL THE CHUCK
Refer to Figure 6
Clean the spindle taper and the tapered hole in the chuck
before assembly. Remove factory protective coating with
alcohol or household oven cleaner.
• Rotate the chuck sleeve counterclockwise and open the
jaws as wide as possible.
• Place chuck on the taper of spindle and gently tape the
chuck into position with a rubber hammer or a hammer
with wood block. Never use metal hammer directly.
Figure 6
MOUNT DRILL PRESS
Refer to Figure 7
• The machine must be installed in a well-lighted area
with correct power supply.
• The machine can be installed on either a workbench or
a tool stand by using bolts, lock washers, and hex nuts.
• The machine must be bolted to a firm and level surface.
• There must be enough clearance for the moving
workpiece during operation. There must be enough
room for safety operation of the machine.
Figure 7
POWER SOURCE
Do not connect to the power source until the machine is
completely assembled.
The machine is wired for 120 volts, 60 Hz alternating
current. Before connecting the machine to the power
source, make sure the switch is in the "OFF" position.
Running the unit on voltages which are not within range
may cause overheating and motor burn-out. Heavy loads
require that voltage at motor terminals be no less than the
voltage specified on nameplate.
• Power supply to the motor is controlled by a locking
rocker switch. Remove the key to prevent unauthorized
use.
GROUNDING INSTRUCTIONS
Improper connection of equipment grounding conductor
can result in the risk of electrical shock.
• The machine should be grounded while in use to protect
operator from electrical shock.
• In the event of an electrical short circuit, grounding
reduces the risk of electrical shock by providing an
escape wire for the electric current.
• This machine is equipped with an approved
3-conductor cord rated at 150V and a 3-prong
grounding type plug (Figure 8) for your protection
against shock hazards.
• Grounding plug should be plugged directly into a
properly installed and grounded 3-prong grounding-type
receptacle, as shown (Figure 8)
• The plug must be plugged into an outlet that is properly
installed and grounded in accordance with all local
codes and ordinances.
• Check with a qualified electrician or service personnel if
these instructions are not completely understood or if in
doubt as to whether the tool is properly grounded.
• Do not modify plug provided. If it will not fit in outlet,
have proper outlet installed by a qualified electrician.
Use only 3-wire extension cords, that have 3-prong
grounding type plugs and matching 3-conductor
receptacles that accept the machine's plug, as show in
Figure 8
4
ASSEMBLY
WARNING
Figure 8 3-Prong Receptacle
Grounded outlet Box
3 - Prong Plug
Grounding Prong
WARNING
WARNING
HEAD
ASSEMBLY
ARBOR
SCRAP
WOOD
MALLET
CHUCK
Mounting Holes
