DESCRIPTION
This jointer is used to surface the faces and edges of
wood to produce a flat surface. The jointer features cast
iron tables, a built-in dust blower for chip removal and
balanced guide fence for the cutting angles at 90°, 45°
(inward) and 45° (outward).
SPECIFICATIONS
Max. cut of depth...........................................................1/8"
Max. width of cut........................................................6-1/8"
Cutterhead speed............................................10,000 RPM
Cuts per minute.........................................................20,000
Table size.........................................................6" W x 24" L
Cutterhead.................................................2-Kinfe, Straight
Cutterhead diameter..................................................1-7/8"
For your own safety, read the operating manual and all
the safety instructions before using the jointer.
SAFETY PRECAUTIONS
• Be aware of general power tool safety. Make sure all the
safety rules are understood.
• Disconnect the machine from power source whenever
adjusting or replacing any parts.
• Do not plug in unless switch is in "OFF" position.
• Keep hands away from all moving parts.
• Wear eye protection or face shield during operation.
• Make sure all guards are attached and securely
fastened. Keep cutterhead and blade guards in proper
working condition.
• Make sure all mobile parts move freely and are free
from interference.
• Keep blades sharp, aligned and properly attached
cutterhead.
• Properly secure the blades in the cutterhead.
• Never turn the machine "ON" with the workpiece
contacting the cutterhead.
• Never make cuts deeper than 1/8" (3.2mm) deep to
prevent kickback.
• Do not force cut. Slowing or stalling will overheat motor.
• Do not perform jointer operations on workpiece shorter
than 10", narrower than 3/4" or less than 1/2" thick.
• Properly support long or wide workpieces.
• Use hold-down/push blocks for jointing any workpiece
lower than the fence.
• Do not perform a workpiece that is warped, contains
knots, or is embedded with foreign objects (nails,
staples, etc) to prevent kickback.
• Do not feed a workpiece into the outfeed end of the
machine.
• Do not attempt to perform an abnormal or little-used
operation without study and the use of adequate
hold-down/push blocks, jigs, fixtures, stops, etc.
• Do not allow anyone to stand or cross in line of
cutterhead rotation. Kickback or thrown debris will travel
in this direction.
• Turn switch off and disconnect power whenever jointer
is not in use.
• Keep jointer maintained. Follow maintenance
instructions.
POSITION FENCE
Turn the switch to OFF position and disconnect the
machine from power source.
The fence can be adjusted to any angles between 45°
inward and 45° outward. There are three positive stops:
90°, 45° inward, and 45° outward. Refer to figure 9 when
adjust the fence
To set the 90° stop:
• Position the fence on the bed. Place sliding handle (7) in
locked position. Loosen the fence tilting handle (6).
WARNING
OPERATION
6
Figure 9 - Limit Stops
1
2
3
5
4
Figure 10
WARNING
8
6
7
a
Knife
the
the
the
