2
• If you notice any transport damage while unpacking,
notify the supplier immediately,
• Dispose of the packing in an environmentally friendly
manner.
You should take into consideration how and where you will
place the unit:
• It can be placed on a bench or be hung from the ceiling.
• This unit will work best if it is located away from corners,
and heating/cooling vents.
• If using on sawhorses the air filtration unit should be
clamped in place.
• This unit is specifically designed to circulate and filter
non-metallic dust, which is generated trhoughout the
work area.
CAUTION: Mounting hooks must be anchored to a building
structure which can support a minimum of 45 kg. Never
mount to surface such as dry wall or false ceiling grids, etc.
Tools required for assembly:
No. 2 Phillips screwdriver (not supplied)
10mm wrench (not supplied)
INSTALLING THE UNIT
Refer to Figure 2 to 4
• Remove all packing from inside of the unit by removing
the outer filter and innner filters.
• The air filtration unit can be hung from the ceiling.
Remove four screws from cabinet top (Figure 2).
• Hang the unit using four hook bolts, and four hex nuts
(Figure 3) provided.
• The lock nut needs to be threaded almost all the way up
the eye bolt. Screw the eye bolt into the hole and tighten
lock nut against the cabinet top. You will need to hold
the eyebolt so it does not spin while tightening the lock
nut.
• Repeat steps for remaining three eyebolts.
• Drill holes and securely mount the four mounting hooks
provided in the ceiling and use the provided sections of
chain for mounting your air filtration system. (Figure 4)
NOTE: Hang the unit at least 7 Ft. above floor level.
Figure 2
Figure 3
Figure 4
ASSEMBLY
2
