PowerTec 365S, Operator'S Manual, Page: 8 / 20

A-4
Setting Welding Voltage
Maintenance
WARNING
For any maintenance or repair operations it is
recommended to contact the nearest Technical Service
Center or Lincoln Electric. Maintenance or repairs
performed by unauthorized service centers or personnel
will null and void the manufacturer's warranty.
The frequency of the maintenance operations may vary
in accordance with the working environment where the
machine is placed.
Any noticeable damage should be reported immediately.
Routine maintenance (everyday)
•
Check cables and connections integrity. Replace, if
necessary.
•
Remove the spatters from the welding gun nozzle.
Spatters could interfere with the shielding gas flow
to the arc.
•
Check the welding gun condition: replace it, if
necessary.
•
Check condition and operation of the cooling fan.
Keep clean its airflow slots.
Periodic maintenance (every 200 working hours
but at list once every year)
Perform the routine maintenance and, in addition:
•
Keep the machine clean. Using a dry (and low
pressure) airflow, remove the dust from the external
case and from the cabinet inside.
• Check and tighten all screws.
WARNING
Mains supply network must be disconnected from the
machine before each maintenance and service. After
each repair, perform proper tests to ensure safety.
Transport
WARNING
To ensure safety transport it is necessary to:
• lift only power source without gas cylinder, cooler
and wire feeder,
• screw down an eye bolt and apply load axially in 45
degree angle in accordance to the drawing.
• ensure equal length of lifting lines.