●
Li-ion battery program:
1) Connecting to the battery.
Connect the Red clip to the Positive terminal of the Li-ion battery,thi s terminal is usually
marked ‘+’or marked in RED.
Connect the Black clip to the Negative terminal of the Li-ion battery,this terminal is usually
marked ‘-‘or marked in BLACK.
2) Plug the DC output terminal of adapter or car lighter in the Input
power hole of the charger/discharger,the displays on the screen is as
the left side,then select the battery type carefully with MD button.
(If not check the power supply and fuse in the main supply).
3)With ST button to confirm the battery type,and choose the function
for charging with MODE(MD) button,The program circle is below
with each press:
0.5A charging.
1.0A charging.
2.0A charging.
2.5A charging.
0.5A discharging…………..
0.5A charging…………..
4) Start the Charging/Discharging program with S/T(Run/Stop)
button while the function in the program you select is on the
screen.(If not check the power supply and fuse in the main supply).
5) At the beginning of the Charging/Discharging program starting, the
charger/discharger will test its condition at that time.
If there are some errors for connectting with the battery, the
following errors displays will be on the screen: a The output is
connected to a battery with incorrect polarity(Reverse polarity/RV)
or shorted.
. b. This will be displayed in case of disconnecting with the Battery
(No battery/NB) or the open circuit of the battery.
6)Resume the process with MODE(MD) button and start it
by S/T(Run/Stop) button.
7) To pause/stop the charging/discharging process,press
S/T(Run/Stop) button for more than 3 seconds(you can
alter the charging current from 0.5A to2.5A with
MODE(MD) button),and you can resume the process with
S/T(Run/Stop
8
）
When the charging/discharging is finished, the audible
sound indicates you the end of process.
