●
NiMH/NiCd battery program:
1) Connecting to the battery.
Connect the Red clip to the Positive terminal of the NiMH/NiMd battery, this terminal is usually
marked ‘+’or marked in RED.
Connect the Black clip to the Negative terminal of the NiMH/NiCd battery, this terminal is usually
marked ‘-‘or marked in BLACK.
2) Plug the DC output terminal of adapter or car lighter in the Input
power hole of the charger/discharger, the displays on the screen is
as the left side
，
then select battery type carefully with MD button.
(If not check the power supply and fuse in the main supply).
3) With ST button to confirm the battery type,and choose the
function for charging with MODE(MD) button,The
program circle is below with each press:
0.5A charging.
1.0A charging.
2.0A charging.
2.5A charging.
0.5A discharging.
0.5A charging…………..
4) Start the Charging/Discharging program with S/T (Run/Stop)
button while the function in the program you select is on the
screen.
5) At the beginning of the Charging/Discharging program starting,
the charger/discharger will test its condition at that time.
If there are some errors for connectting with the battery, the
following errors displays will be on the screen:
a The output is connected to a battery with incorrect
polarity(Reverse polarity/RV) or shorted.
. b. This will be displayed in case of disconnecting with the
battery(No battery/NB) or the open circuit of the battery.
6)Resume the process with MODE(MD) button and start it by
S/T(Run/Stop) button.
7) To pause/stop the charging/discharging process,press S/T(Run/Stop)
button for more than 3 seconds(you can alter the charging current
from 0.5A to2.5A with MODE(MD) button),and you can resume the
process with S/T(Run/Stop) button.
8
）
When the charging/discharging is finished, the audible sound
indicates you the end of process
