9
English
Do not force the tool
. Let it do the work. Light pressure is all that is required for sanding, polishing
and scrubbing. Excessive pressure will slow the motor, rapidly wear sandpaper, reduce sander speed
and produce inferior results. Any finish or resin on wood may soften from frictional heat. Do not sand on
one spot for too long, as sander may remove too much material, making your surface uneven.
Extensive periods of sanding may tend to overheat the motor.
If it this occurs, turn
sander off and wait until sandpaper comes to a complete stop, then remove it from the work piece,
remove the battery pack and let it cool down before using it again.
CAUTiON
:
To avoid damaging the motor from overheating, be careful not to let
your hand cover the air vents.
For detail sanding such as corners and crevices
, use the tip of the sanding pad with small
back and forth motions.
Summary of Contents for MAGLITHION MLMS12C
Page 39: ...39 NOTES...
Page 40: ...40 NOTES...
