PowerShield Centurion PSCE1000, User Manual

Page: 4 / 24

www.powershield.com.au 3
1. Important Safety Warning
Please comply with all warnings and operating instructions in this manual. Save this manual
properly and read carefully the following instructions before installing the unit. Do not operate
this unit before reading through all safety information and operating instructions carefully
1-1. Transportation

Please transport the UPS system only in the original package to protect against shock
and impact.
1-2. Preparation
 C
ondensation may occur if the UPS system is moved directly from cold to warm
environment. The UPS system must be absolutely dry before being installed. Please
allow at least two hours for the UPS system to acclimate to the environment.

Do not install the UPS system near water or in moist environments.

Do not install the UPS system where it would be exposed to direct sunlight or near
heater.

Do not block ventilation holes in the UPS housing.
1-3. Installation

Do not connect appliances or devices which would overload the UPS system (e.g.
laser printers) to the UPS output sockets.

Place cables in such a way that no one can step on or trip over them.

Do not connect domestic appliances such as hair dryers to UPS output sockets.

The UPS can be operated by any individuals with no previous experience.

Connect the UPS system only to an earthed shockproof outlet which must be easily
accessible and close to the UPS system.

Please use only VDE-tested, CE-marked mains cable (e.g. the mains cable of your
computer) to connect the UPS system to the building wiring outlet (shockproof
outlet).

Please use only VDE-tested, CE-marked power cables to connect the loads to the UPS
system.

Pluggable equipment includes a protective earth conductor that carries the leakage
current from the load devices ( computer equipment ). Total leakage current must not
exceed 3.5mA.