PowerPoint P4145MDWCDZ, Instructions Manual

Page: 7 / 24

to be changed a fuse of the same rating must be used. Ensure that the fuse
cover is refitted.
1. Install the wine cooler on a flat surface in order to prevent vibration
and noise.
2. The cord should be secured behind the appliance to avoid injury
3. Choose a dry well-ventilated place
4. Choose a location where there is no heat source. Keep the
refrigerator away from direct sunlight, oven etc.
5. Do not place the appliance near cookers, radiators or in direct
sunlight as this will cause your appliance to work harder.
6. Don’t install this appliance in a wall recess or into fitted cabinets.
7. Allow a gap of 10mm between top surface and wine cooler.
8. Allow a gap of 5 mm either side or back of the unit.
9. Ensure that your appliance is level
Before you start using the refrigerator check that:
1. The interior is dry and air can circulate freely at the rear of the cabinet.
2. Clean the interior as recommended under "CLEANING AND CARE."
3. Insert the plug into the wall socket and switch on the electricity supply.
4. You will hear a noise as the compressor starts up. The liquid and gases
sealed within the refrigeration system may also give rise to noise
which is quite normal.
5. Front edges of the cabinet may feel warm. This is normal.
6. Do not load the appliance immediately it is switched on. Wait until the
Correct storage temperature has been reached. We recommend that
You check the temperature with an accurate thermometer or wait 24
hours.
Installation Instructions
Control Panel
7