POWXQG7555
EN
Copyright © 2017 VARO
P a g e
|
9
www.varo.com
Regularly clean the sideward flap and discharge opening form grass rest and stuck dirt.
Mount the grass catch bag:
To fit: raise the rear cover and hitch the grass catch bag on rear of mower.
To remove: grasp and lift the rear cover, remove the grass catch bag.
7.2.4
Edge cutting
Lawn mower is designed so that the diameter of the deck lies outside the line of wheels. In this
way you can cut the edges very easily.
8 OPERATING INSTRUCTIONS
8.1
Before starting
Service the engine with gasoline and oil.
WARNING! Petrol is highly flammable.
Store fuel in containers specifically designed for this purpose.
Refuel only outdoors before starting the engine and do not smoke while refuelling or handling
fuel.
Never remove the cap of the fuel tank or add petrol while the engine is running or when the
engine is hot.
If petrol is spilled, do not attempt to start the engine but move the machine away from the area
of spillage and avoid creating any source of ignition until petrol vapours have dissipated.
Replace all fuel tanks and container caps securely.
Before tipping the lawn mower to carry out any work on the blade or drain oil, remove fuel from
tank.
WARNING: never fill fuel tank indoors, with engine running or until the
engine has been allowed to cool for at least 15 minutes after running.
8.2
To start engine and engage blade
Before start, adjust the speed adjusting lever at “1”-position.
1.
The unit is equipped with a rubber boot over the end of the spark plug. Make certain the
metal loop on the end of the spark plug wire (inside the rubber boot) is fastened securely
over the metal tip on the spark plug.
2.
When starting cool or warm engine, turn throttle choke lever at anywhere between “
”position to “
”position.
3.
When operating, turn throttle choke lever to “
”position. (Fig. 10A, Fig. 10B)
4.
Standing behind the unit grasp the brake control handle and hold it against the upper
handle as shown in fig. 10C.
5.
Grasp the starter handle as shown Fig. 10C and pull up rapidly. Return it slowly to the
rope guide bolt after engine starts.
6.
Release the brake control handle to stop the engine and blade.
Start the engine carefully according to instructions and with feet well away
from the blade.
