POWX07551T
EN
Copyright © 2016 VARO
P a g e
|
7
www.varo.com
Do not use saw blades made of HSS steel.
Do not use bent, deformed or otherwise damaged saw blades.
Do not use saw blades which do not meet the specifications stated in this manual.
Before sawing, remove all nails and other metal objects from the workpiece.
Never start sawing before the saw reaches its full speed.
Securely clamp the workpiece.
Never attempt to saw extremely small workpieces.
Only leave the machine after switching off and when the saw blade has come to a
complete standstill. Pull down the saw head and press in the locking knob.
Never try to slow the saw blade down by exerting pressure on the side.
Before performing maintenance to the machine, always unplug the machine.
7 ADDITIONAL SAFETY INSTRUCTIONS FOR LASERS
WARNING! The laser beam potentially causes severe eye damage. Never
look or stare directly into the laser beam.
During use, do not point the laser beam at people, directly or indirectly
through reflecting surfaces.
The unit includes no servicing components. Do not open the housing for any reason. If the
unit is damaged, have the damage repaired by an authorized repair agent
8 ASSEMBLY
WARNING! To avoid injury, do not connect this mitre saw to a power source
until it is completely assembled and adjusted and you have read and
understood the operator’s manual.
8.1
Installing the mitre handle (Fig. 1)
Thread the mitre handle (E) into the hole located at the front of the mitre saw (A).
8.2
Installing the dust bag (Fig. 2)
Squeeze the metal collar wings on the dust bag (C).
Place the dust bag neck opening around the exhaust port on the mitre saw (A) and
release the metal collar wings.
NOTE: To empty the dust bag, squeeze the metal collar wings and remove
from exhaust port. Open zipper on underside of bag and empty into waste
container.
IMPORTANT: Check frequently and empty bag before it gets full.
WARNING! Do not use this saw to cut and/or sand metals. The hot chips or
sparks may ignite sawdust from the bag material.
8.3
Installing the hold-down clamp (Fig. 3)
NOTE: There are two mounting holes for the hold-down clamp. These are
located just behind the fence on the left and right side of the base.
