POW X0153, 0155 & 0157
EN
Copyright © 2011 VARO
P a g e
| 6
www.varo.com
6.
Do not cause short circuits. If connection is made between the positive (+) and
negative (-) terminal directly or via accidental contact with metallic objects, the
battery is short circuited and an intense current will flow causing heat generation
which may lead to casing rupture or fire.
7.
Do not heat. If batteries are heated to above 100 °C, sealing and insulating
separators and other polymer components may be damaged resulting in electrolyte
leakage and/or internal short circuiting leading to heat generation causing rupture or
file. Moreover do not dispose of the batteries in fire, explosion and/or intense
burning may result.
8.
Under extreme conditions, battery leakage may occur. When you notice liquid on
the battery, proceed as follows:
- Carefully wipe the liquid off using a cloth. Avoid skin contact.
- In case of skin or eye contact, follow the instructions below:
i. Immediately rinse with water. Neutralize with a mild acid such
as lemon juice or vinegar.
ii. In case of eye contact, rinse abundantly with clean water for at
least 10 minutes. Consult a physician.
Chargers
1.
Use the charger provided with the tool only to charge the battery
2.
Never attempt to charge non-rechargeable batteries.
3.
Have defective cords replaced immediately.
4.
Do not expose to water.
5.
Do not open the charger.
6.
Do not probe the charger.
7.
The charger is intended for indoor use only.
7 FEATURES
7.1
Keyless chuck (1)
Your drill has a keyless chuck that allows you to hand tighten or release drill bit in the chuck
jaws.
7.2
Torque adjustment ring (2)
The drill has a torque adjustment ring. It allows you to select the desired torque depending on
the task you have to perform (drill / different types of screws into different materials). The
proper setting depends on the type of material and the size of screw you are using.
7.3
On/off switch (4)
The switch trigger can be locked in the OFF position. This feature helps reduce the possibility
of accidental starting when not in use.
7.4
Forward/reverse selector (right/left rotation selector) (7)
The drill has a forward/reverse selector located above the switch trigger.
Press selector F(orward) on left side of machine (to the right side): drill turns right
(forward/fasten screws).
Press selector R(everse) on right side (to the left side): drill turns left (reverse/loosen
screws).
CAUTION: To prevent damage to the gearbox, always allow the chuck to come to a complete
stop before changing the direction of rotation or selecting another speed (HI-LO). To stop,
release the trigger switch.
